PLEASE READ CAREFULLY.
All of our belts are made according to the specifications that you, the customer provide.. Please follow the directions below and measure your belt size accurately. This is important as we cannot accept exchanges, or returns on belts made to the size indicated on your order.
ABSOLUTELY NO EXCEPTIONS! 

Lay your belt out flat and measure from the inside far edge of the buckle (A) to the hole that you currently use (B).  Please remember when ordering, to take into account any holster or accessory that will be worn inside the waistband and add extra length as needed. Bulman Gunleather will not be held responsible for inadequate measurements that are provided to us which do not take into account the intended use of the belt. Any extra length that is needed, is to be determined by you according to your specific needs. On average,  2 inches of extra length will usually suffice for an IWB holster, but there is no set formula for determining that factor as everyone can be a bit different.  The most accurate method of determining the proper length is to take a measurement with the actual gear you will be carrying in place. If you don't already have an IWB holster, you can always tuck your un-loaded weapon into the waistband, at the position in which the IWB holster will be worn, usually at about 3 to 4 O'clock. With your belt in 
place over the gun, take note of which adjustment hole the tongue of your buckle is now in and measure your belt as described and pictured above. The same instructions would apply to any other accessories you may wish to carry IWB. The measurement that you provide to us will be the center hole on your new belt. The hole spacing on all of our belts is 3/4" from center to center of the 5 holes. 

Please feel free to give us a call for any clarification you may need on how to measure. 
Bulman Gunleather (814) 696-8615